- RFI (woven metallic) gasket ensures against ingress/egress interference, >100dB RFI shielding

- Stainless steel hardware and aluminum port caps for corrosion resistance

- Aluminum alloy housing with weather resistant powder coating and spray painting

- Weather seal gasket ensures water tight protection, tested at 15 psi / 60s

- Umbrella-effect housing design prevents accumulation of water at ports

- Weatherproof, self-sealing ‘F’ ports prevent breathing through ports when subscriber is disconnected; epoxy glue (or high quality silicon glue) on all F-ports inside

- Bright Tin- or Ni-plated, brass ‘F’ ports offer increased strength and protection against corrosion in severe environmental conditions

- Heat shrink ridges for easy installation

- 2-layer P.C.B Printed Circuit Board with high quality FR4 board for RF applications

- Support plug- in attenuation module for easy to exchange the tap value/tap loss

- Include signal / power passing bar when faceplate is removed (Uninterrupted power passing)

- Waterproof Condition: 15 psi (1.0 kg/cm2)

- All IN and OUT ports are 5/8-24 female standard, all TAP ports are 3/8-32 female standard; Nominal Impedance (all ports): 75 Ohms

- Power Passing: 10A, 90 VAC (IN  - OUT)

- Using high quality chip capacitors and chip resistors

- High Voltage Blocking Capacitors - All ports Surge Withstand: All Tap ports at IEEE C62.41-1991 Category A3 (0.5 μs - 100 kHz Ring Wave,  6000 V, 200 A), Input / Output ports at IEEE C62.41-1991 Category B3 (1.2/50 μs - 8/20 μs Combination Wave, 6000 V, 3000 A)